Drive Plates

Nascar Drive Plate ADC102


Part Number: ADC102

Used in conjunction with Strange Oval axles, our spline tolerances, between the axle splines and drive plate splines, is usually tighter and more uniform. These “closely mated” tolerances will provide better spline life of both the axles and drive plates. Strange Oval offers several steel drive plates that will accommodate a camber range of zero to 4 degrees. Depending on where your current rules regarding allowable camber lies (if any)

    • Nickel Chromium Molybdenum steel for excellent hardenability, strength, and toughness to provide good spline wear and drive flange longevity
    • FEA (Finite Element Analysis) analyzed lightweight scalloped and pocketed design
    • Dry film solid lubricant applied to insert gear to prevent galling and increase lubricity
    • Marquenching heat-treat processing reduces distortion and residual stress
    • electropolishing enhances surface finish especially beneficial on the spline flanks for reduced friction, reduced wear, and lower operating temperatures
  • Broached splines promote consistent fit and misalignment angle
  • 2 piece drive plate #ADC102 can be run with standard crowned spline axles and can accommodate 0 to 3.5 degrees of camber with the articulating splined insert. This drive plate must be used with the standard crowned splined axles (not straight splined axles – see drive plate ADC102)

Additional information

Weight 4.0 lbs